In any presentation covering the quantitative physics of a class of systems, it is important to beware of the units of measurement used! In this presentation of stepping motor physics, we will assume standard physical units:5916
English CGS MKS
MASS slug gram kilogram
FORCE pound dyne newton
DISTANCE foot centimeter meter
TIME second second second
ANGLE radian radian radian
A force of one pound will accelerate a mass of one slug at one foot per second squared. The same relationship holds between the force, mass, time and distance units of the other measurement systems. Most people prefer to measure angles in degrees, and the common engineering practice of specifying mass in pounds or force in kilograms will not yield correct results in the formulas given here! Care must be taken to convert such irregular units to one of the standard systems outlined above before applying the formulas given here!
Statics
For a motor that turns S radians per step, the plot of torque versus angular position for the rotor relative to some initial equilibrium position will generally approximate a sinusoid. The actual shape of the curve depends on the pole geometry of both rotor and stator, and neither this curve nor the geometry information is given in the motor data sheets I've seen! For permanent magnet and hybrid motors, the actual curve usually looks sinusoidal, but looks can be misleading. For variable reluctance motors, the curve rarely even looks sinusoidal; trapezoidal and even assymetrical sawtooth curves are not uncommon.
For a three-winding variable reluctance or permanent magnet motors with S radians per step, the period of the torque versus position curve will be 3S; for a 5-phase permanent magnet motor, the period will be 5S. For a two-winding permanent magnet or hybrid motor, the most common type, the period will be 4S, as illustrated in Figure 2.1:
Figure 2.1
Again, for an ideal 2 winding permanent magnet motor, this can be mathematically expressed as:
T = -h sin( (( /2) / S) )
Where:
T -- torque
h -- holding torque
S -- step angle, in radians
= shaft angle, in radians
But remember, subtle departures from the ideal sinusoid described here are very common.
The single-winding holding torque of a stepping motor is the peak value of the torque versus position curve when the maximum allowed current is flowing through one motor winding. If you attempt to apply a torque greater than this to the motor rotor while maintaining power to one winding, it will rotate freely.
It is sometimes useful to distinguish between the electrical shaft angle and the mechanical shaft angle. In the mechanical frame of reference, 2 radians is defined as one full revolution. In the electrical frame of reference, a revolution is defined as one period of the torque versus shaft angle curve. Throughout this tutorial, refers to the mechanical shaft angle, and (( /2)/S) gives the electrical angle for a motor with 4 steps per cycle of the torque curve.
Assuming that the torque versus angular position curve is a good approximation of a sinusoid, as long as the torque remains below the holding torque of the motor, the rotor will remain within 1/4 period of the equilibrium position. For a two-winding permanent magnet or hybrid motor, this means the rotor will remain within one step of the equilibrium position.
With no power to any of the motor windings, the torque does not always fall to zero! In variable reluctance stepping motors, residual magnetization in the magnetic circuits of the motor may lead to a small residual torque, and in permanent magnet and hybrid stepping motors, the combination of pole geometry and the permanently magnetized rotor may lead to significant torque with no applied power. 步进电机物理原理英文文献和中文翻译:http://www.751com.cn/fanyi/lunwen_3199.html