Heat Treatment of Die and Mould Oriented Concurrent Design
Traditional die and mould design, mainly by experience or semi—experience，is isolated from manufacturing process. Before the design is finalized，the scheme of die and mould is usually modified time and again，thus some disadvantages come into being, such as long development period, high cost and uncertain practical effect. Due to strong desires for precision, service life, development period and cost, modern die and mould should be designed and manufactured perfectly. Therefore more and more advanced technologies and innovations have been applied, for example, concurrent engineering, agile manufacturing virtual manufacturing, collaborative design, etc.8009
Heat treatment of die and mould is as important as design, manufacture and assembly because it has a vital effect on manufacture，assembly and service life．Design and manufacture of die and mould have progressed rapidly，but heat treatment lagged seriously behind them．As die and mould industry develops，heat treatment must ensure die and mould there are good state of manufacture，assembly and wear—resistant properties by request. Impertinent heat treatment can influence die and mould manufacturing such as over—hard and—soft and assembly．Traditionally the heat treatment process was made out according to the methods and properties brought forward by designer．This could make the designers of die and mould and heat treatment perge from each other，for the designers of die and mould could not fully realize heat treatment process and materials properties，and contrarily the designers rarely understood the service environment and designing thought. These pergences will impact the progress of die and mould to a great extent. Accordingly，if the process design of heat treatment is considered in the early designing stage，the aims of shortening development period，reducing cost and stabilizing quality will be achieved and the sublimation of development pattern from serial to concurrent will be realized．
Concurrent engineering takes computer integration system as a carrier, at the very start subsequent each stage and factors have been considered such as manufacturing，heat treating，properties and so forth in order to avoid the error．The concurrent pattern has dismissed the defect of serial pattern, which bring about a revolution against serial pattern．
In the present work．the heat treatment was integrated into the concurrent circumstance of the die and mould development，and the systemic and profound research was performed．
1  Heat Treatment Under Concurrent Circumstance
The concurrent pattern differs ultimately from the serial pattern(see Fig．1).With regard to serial pattern，the designers mostly consider the structure and function of die and mould，yet hardly consider the consequent process，so that the former mistakes are easily spread backwards．Meanwhile，the design department rarely communicates with the assembling，cost accounting and sales departments．These problems certainly will influence the development progress of die and mould and the market foreground．Whereas in the concurrent pattern，the relations among departments are close，the related departments all take part in the development progress of die and mould and have close intercommunion with purchasers．This is propitious to elimination of the conflicts between departments，increase the efficiency and reduce the cost．
Heat treatment process in the concurrent circumstance is made out not after blueprint and work piece taken but during die and mould designing．In this way，it is favorable to optimizing the heat treatment process and making full use of the potential of the materials．

2  Integration of Heat Treatment CAD／CAE for Die and Mould
It can be seen from Fig．2 that the process design and simulation of heat treatment are the core of integration frame．After information input via product design module and heat treatment process generated via heat treatment CAD and heat treatment CAE module will automatically pide the mesh for parts drawing，simulation temperature field microstructure analysis after heat—treatment and the defect of possible emerging (such as overheat, over burning)，and then the heat treatment process is judged if the optimization is made according to the result reappeared by stereoscopic vision technology．Moreover tool and clamping apparatus CAD and CAM are integrated into this system． 模具结构并行设计的热处理工艺英文文献和中文翻译:http://www.751com.cn/fanyi/lunwen_6186.html