摘要本文主要是针对口径为35MM的火炮身管缠度进行测试，由于口径比较小，该项目采用手动测试（手动推杆的方式）的方法进行缠度或导程测量，采用两个角度编码器，分别测量角度和位移，通过一定计算方法来获取火炮身管的缠度或导程，组建了一套手动缠度测量系统，并达到了要求的主要技术指标。系统包括硬件和软件两部分，该论文负责相关硬件选择、调试和数据分析，以及基于labvieW软件设计，硬件主要包括角度编码器 、测试机构和PXI数据采集器系统；软件主要包括使用labview7.1编写的程序，信号调理，数据采集，数据分析。主要完成以下任务：通过数据采集卡把轴角编码器前进或后退产生的长度信号和角度信号，送信号处理电路进行处理，再送至PC主机去进行处理。主机处理后会在屏幕上显示出结果：数据表示和波形表示，也可进行打印输出。61402
毕业论文关键词 缠度 火炮 labview7.1 轴角编码器
毕业设计说明书（论文）外文摘要
Title Twist the system hardware and software design of tube
Abstract This paper is mainly on the diameter of twist for testing 35MM gun tube, the diameter is relatively small, the manual test using the project (manual push rod way) method for twist or lead measurement, using two angle encoder, angle and displacement measurement, to obtain the gun barrel twist or guide pass a calculation method, a set of manual twist measurement system, and the main guide. System includes both hardware and software parts, The paper is responsible for the relevant hardware selection , commissioning and data analysis as well as software based Labview. The hardware includes angle encoder, testing agencies and PXI data acquisition system, Software includes programs written using labview7.1 , signal conditioning , data acquisition , data analysis. Mainly completed the following tasks: through the data acquisition card to shaft angle encoder forward or backward the length of signal and angle signal, send a signal processing circuit for processing, and then sent to the PC host to be processed. The main processing will display the results on the screen: the representation of data and waveform said, can also print output.
Keywords twist the shaft labview7.1 Shaft encoder
1 引言 1
1.1 缠度检测系统研究的目的和意义 1
1.2 缠度检测的发展状况 2
1.3 系统研究的目的和意义 3
2 总体设计方案 4
2.1 缠度知识介绍 4
2.2 缠度检测方法的选取 5
2.3 缠度检测系统设计的要求 5
2.4 缠度检测系统总体设计方案 6
2.5 硬件总体设计方案 8
3 硬件系统设计 9
3.1系统结构与原理 9
3.2 主要器件的选择 10
4 软件总体设计方案 17
4.1 系统运行环境 17
4.2 软件设计方案 18
4.3 程序详细设计 22
5 实验分析与数据处理 33
5.1 实验分析 labview735MM身管缠度系统设计软件与硬件部分:http://www.751com.cn/jixie/lunwen_67153.html