菜单
  

    The value of fb ¼ 18 for CW is based on the average value of friction angle measured atthe base of the CW which is similar to the steel rod–steel plateinterface friction angle obtained in a direct shear test. The value offb ¼ 22  is also based on a tilting table test for the reinforcement–steel rod interface; the steel rod–steel rod friction angle is based onthe direct shear test reported by Huang and Luo (2009),assummarized in Table 3.3. Behavior of soil retaining walls situated onnon-deformable and deformable foundationsFigs. 6a,b show measured settlements of the foundation ata level of 100 mm below the wall base of the CW and GRS-BW,respectively. For a similar value of kv, the curves of the foundationsettlement for the CW and GRS-BW are similar in magnitude andshape as a result of the self-weight of the backfill and the surcharge.It can also be seen that far from the toe, the ground settlementapproaches a uniform state. A significant differential settlement exists around the toe of CW and GRS-BW, reflecting the abruptchange of the self-weight and surcharge loads across the toe of thewall.Fig. 7a shows the developed shear bands in the backfill of CWsituated on the ground of kv ¼NkPa/mm and subjected toa surcharge q of 17 kN/m2. A pair of shear bands, both with an angleof 63  to the horizontal, can be observed. These shear bands areapproximately in the direction of the maximum stress obliquity(equal to 45  þ f/2 ¼ 62.5 ). Fig. 7b shows the shear band and walldisplacements for the wall shown in Fig. 7a. It can be seen thata maximum vertical settlement at the top of the wall, 2.4 mm (Dv/H ¼ 0.0048), was measured in this case; it was induced by thedeformation of the 100 mm-thick backfill above the rigid founda-tion. A foundation settlement of this order can be deemed as a caseof the unyielding subgrade condition.Figs. 8a,b show shear band development and displacements,respectively, for a CW placed on a foundation of kv ¼ 1.8 kPa/mm.More intensively sheared backfill and greater vertical and hori-zontal displacements of the wall induced by a greater foundationsettlement as compared to those shown in Figs. 7a,b, can be seen.Note that the settlements and displacements shown in thesefigures were amplified for better visibility. Figs. 9a,b showthe shearbands and displacements of a CW placed on the ground ofkv ¼ 1.3 kPa/mm (the lowest value of kv in the present study, Smax/Ht j10%). It is noted that the number of shear bands significantlydecreased compared to the case of kv ¼ 1.8 kPa/mm. A verticalsettlement of the wall, Dv ¼ 9.2 mm (Dv/H ¼ 0.018), and maximumvalues of Smax/H ¼ 0.072 and 0.094 are all greater than thoseobserved in previous cases. However, themaximumwall horizontaldisplacement of the wall, Dh ¼ 6.1 mm (Dh/H ¼ 0.012), is smallerthan those of cases using kv ¼ 3.6 and 1.8 kPa/mm. This suggests that a greater foundation settlement does not necessarily introducea greater horizontal displacement of the CWor aworse condition ofthe backfill in terms of the integrity (or intensity of shear bands).This occurs because a large settlement of Smax/Hj10% facilitatesa tilting-backward mode, inhibiting active failures in the backfill.An increase of passive resistance in front of thewall due to a greaterwall settlementmay also account for the increase ofwall stability inthe case of kv ¼ 1.3 kPa/mm (Smax/Hj10%). This issue was firstdiscussed by Huang and Luo (2009).Figs. 10a,b show the shear band development and displacementof facing for a GRS-BW placed on an unyielding foundation. Alongwith very limited wall displacements, an intact backfill zone evenunder a fully loaded condition of q ¼ 17 kN/m2can be observed.Figs. 11a,b show the case of GRS-BW situated on the ground ofkv ¼ 1.8 kPa/mm. The wall displacements and foundation settle-ment increase to some extent in response to a decreased subgradereaction coefficient from the previous case of kv ¼ 3.6 kPa/mm.Only a pair of shear bands appeared. A contrast in the response tofoundation yielding can be seen by comparing Figs. 8b and 11b. Theoverall ductility of GRS-BW, which may be a result of backfill-reinforcement interaction, can be observed. Fig. 11b shows that theshear band that developed on the left side of the backfill is probablydue to a small rotation on the left-end of the foundation slab and isirrelevant to the integrity of the backfill.
  1. 上一篇:格室加筋砂土地基土相对密度性能的影响英文文献和中文翻译
  2. 下一篇:垂直振动下桩基的非线性动态反应英文文献和中文翻译
  1. 网上购物英文文献和中文翻译

  2. 船舶设计问题上的新全局...

  3. 车身外表面变形校正方法英文文献和中文翻译

  4. 数控车床上磨削主轴的分析

  5. 格室加筋砂土地基土相对...

  6. 冷挤压变形特性英文文献和中文翻译

  7. 模具冲压模具变形英文文献和中文翻译

  8. 大众媒体对公共政策制定的影响

  9. 十二层带中心支撑钢结构...

  10. 酸性水汽提装置总汽提塔设计+CAD图纸

  11. 当代大学生慈善意识研究+文献综述

  12. 中考体育项目与体育教学合理结合的研究

  13. 乳业同业并购式全产业链...

  14. 河岸冲刷和泥沙淤积的监测国内外研究现状

  15. java+mysql车辆管理系统的设计+源代码

  16. 电站锅炉暖风器设计任务书

  17. 杂拟谷盗体内共生菌沃尔...

  

About

751论文网手机版...

主页:http://www.751com.cn

关闭返回