菜单
  
    摘要并联有源滤波器中交流纹波通常采用输出滤波器(output filter,OF)来抑制。LCL输出滤波器较L、LC型具有更优越的性能,成为研究的热门。目前LCL输出滤波器多采用限制条件确定参数范围,在范围内凑试,直至所有性能指标均满足要求。工作量大,需反复凑试。针对以上问题,本文通过分析输出滤波器参数对纹波抑制的性能指标的影响,提出一种图解设计方法。通过参数与性能的等式关系及限制条件作图,在图中得到满足要求的参数区域,折衷考虑各项性能,直接从图中读出满足条件的滤波器参数。本文进一步通过引入虚拟阻尼来抑制LCL滤波器系统谐振峰,减少了引用电阻器件的成本,同时对相位进行补偿,进一步提高了系统的稳定性。30984
    关键词     纹波电流   LCL输出滤波器    虚拟电阻 
    毕业论文设计说明书外文摘要
    Title    Inhibition of ripple current on the AC side   in the active filter           
    Abstract
    It is commonly that we use output filter (OF) to suppress  AC ripple   in Shunt Active Filter 。Because its better performance compared with L, LC output filter,LCL output filter  type become a hot research. Currently,we always restrictions to determind the  parametersuse when we design LCL output filter ,and within the scope ,we need  trial and error until all performance requirements are met. This leads to a large amount of work,and need to be repeated trial and error. To solve the above problem, this paper analyzes the impact of the performance parameters of the output filter ripple rejection of the proposed graphic design. By equation parameters and performance relationship with restrictions,we can plot a map. In the drawing , we can obtain the area of parameters in which requirements to be met, Compromise the performance,we can read out OF parameters directly from the graph which meet the conditions . This article introduces a virtual damper to suppresse resonance peak of LCL filter system, reducing the cost of  resistance. Meanwhile, it compensates for the phase which further improves the stability of the system .
    Keywords  LCL output filter    ripple current    virtual damper
    目   录
    1  绪论    1
    1.1  背景意义    1
    1.2  研究现状    2
    1.3  目前研究存在的问题    3
    2  APF主电路中常用的输出滤波器    5
    2.1  常用输出滤波器拓扑结构    5
    2.2  电路的频率响应分析    5
    3  基于LCL型输出滤波器的纹波抑制    10
    3.1  电路拓扑结构    10
    3.2  电路结构的数学分析    11
    3.3  LCL输出滤波器的设计    14
    4  基于虚拟电阻的LCL型输出滤波器的优化    16
    4.1  引入虚拟电阻的输出滤波器结构分析    16
    4.2  基于虚拟电阻的LCL型输出滤波器的优化过程    18
    5  仿真与结果分析    20
    结  论    24
    致  谢    25
    参考文献26 
    1  绪论
    1.1  背景意义
    随着电力电子技术的迅速发展,各种非线性半导体器件得到广泛的应用,谐波对电网的污染日益严重。高次谐波造成的设备故障和事故时有发生。同时由于谐波带来的设备利用率降低、备用容量增加等也给正常的生产造成很大的影响,同时加大了电网的负担,降低了供电质量。谐波成为影响电能质量最主要的因素之一,国内外已经对谐波从电压波形畸变率,谐波电压含量,谐波电流含量等方面制订了详细的标准。我国已有的标准有GB12326-90、GB/T15543-1995和GB/T14549-93等标准[1,2] ,在国际上IEC555-2、IEEE519-1992等标准[3],这些标准,从各个方面规定了系统正常工作的条件,使系统能够被控制在稳定工作范围内,同时为滤波器的设计提供了性能标准。消除电网中的谐波,净化电能质量成为用户关注的焦点。
  1. 上一篇:MATLAB基于主分量分析的数据处理和分类
  2. 下一篇:县城110kV降压变电站设计+电路图
  1. APF电力系统有源滤波器设计

  2. 曲率法电力系统暂态稳定分析初探

  3. ARM7远程IAP在电力监控终端上的应用+代码

  4. 随机系统鲁棒控制滤波器设计问题研究与仿真

  5. Matlab含柔性输电元件的电...

  6. Labview可视化电力系统安全...

  7. Saber有源储能电感变换器及...

  8. 电站锅炉暖风器设计任务书

  9. 十二层带中心支撑钢结构...

  10. 大众媒体对公共政策制定的影响

  11. java+mysql车辆管理系统的设计+源代码

  12. 中考体育项目与体育教学合理结合的研究

  13. 乳业同业并购式全产业链...

  14. 酸性水汽提装置总汽提塔设计+CAD图纸

  15. 河岸冲刷和泥沙淤积的监测国内外研究现状

  16. 当代大学生慈善意识研究+文献综述

  17. 杂拟谷盗体内共生菌沃尔...

  

About

751论文网手机版...

主页:http://www.751com.cn

关闭返回